2017-2018 Macan – Manual

2017-2018 Macan – Manual

Go to Exterior    |    Go to Interior    |    Go to PCM

Page: 279

Uniform Tire Quality Grading

Fig. 233: Treadwear, Traction and Temperature of the tire

Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. All passenger vehicle tires must conform to Federal Safety Requirements in addition to these grades. Quality grades can be found where applicable.

Traction AA, A, B, C

The traction grades, from highest to lowest, are AA, A, B, and C and they represent the tire's ability to stop on wet pavement as measured under controlled conditions on specified government test surfaces of asphalt and concrete. A tire marked C may have poor traction performance.

The traction grade assigned to this is based on braking (straight-ahead) traction tests and does not include cornering (turned) traction, acceleration, hydroplaning or peak traction characteristics.

Temperature A, B, C

The temperature grades are A (the highest), B and C, representing the tire's resistance to the generation of heat and its ability to dissipate heat when tested under controlled conditions on a specified indoor laboratory test wheel.

Sustained high temperatures can cause the material of the tire to degenerate and reduce tire life, and excessive temperature can lead to sudden tire failure.

The grade C corresponds to a level of performance which all passenger vehicle tires must meet under the Federal Motor Vehicle Safety Standard No. 109.

Grades B and A represent higher levels of performance on the laboratory test wheel than the minimum required by law.

Tire Abuse
The temperature grade for this tire is established for a tire that is properly inflated and not overloaded. Excessive speed, underinflation, or excessive loading, either separately or in combination, can cause heat buildup and possible tire failure.

  • Do not exceed the permitted maximum speed for the tires fitted to the vehicle.
  • Ensure that the tires are set to the correct inflation pressure.
  • Observe the maximum load for the vehicle.


Overloading Tires
Overloading can lead to dangerous vehicle reactions and long braking distances.

  • Do not overload your vehicle. Be careful about the roof load.
  • If you plan to load the vehicle, first correct the tire pressure. Tire pressure for loaded vehicle can be found on the tire pressure plate and in the chapter technical data.
  • Never exceed the specified axle load.

Quick Index
View all Videos