718

Cayenne

2017-2018 Macan – Manual

2017-2018 Macan – Manual

Go to Exterior    |    Go to Interior    |    Go to PCM

Page: 120

Garage Door Opener (HomeLink®)

Using the vehicle garage door opener

Fig. 70: Buttons for the HomeLink® system

The HomeLink® system on your Porsche can be used to activate radio-controlled equipment (e.g. garage doors/property gates, security systems, house lighting) from the interior of the vehicle.

The HomeLink® system replaces up to three different original remote controls. The signal from a remote control can be assigned to one of the three memory buttons on the overhead console. The relevant equipment can then be operated using the programmed button.

  • Observe the instructions for the original remote control.

Information
For information on the compatibility of the vehicle's HomeLink® system with the original hand transmitter can be obtained from

  1. Contact an authorized Porsche dealer.
  2. Use www.homelink.com, the toll-free HomeLink® hotline (0) 0800 046 635 465 or (0) 8000 HOMELINK.

Pinching, crushing or impact through operated equipment
If persons or animals are in the movement area of the operated equipment, there is a risk of injury while the garage door opener is being operated or programmed.

  • Make sure there are no persons, animals or objects in the movement area of the operated equipment while the HomeLink® system is being operated or programmed.
  • Observe the safety instructions for the original remote control.

Information

  • Before selling your vehicle, remember to delete the garage door opener signals.

Operating the garage door opener

  1. Ignition is switched on.
  2. The vehicle faces the receiver and is within the receiver range (signal is transmitted forward in the direction of travel).
  • Press and hold the relevant HomeLink® button on the overhead console.
    The light indicator on button (Fig. 70) lights up during signal transmission.

Programming the garage door opener

The HomeLink® system is programmed on the overhead console and in the direct vicinity of the front of the vehicle.

  1. The ignition is switched on.
  2. Turn signals are switched off.
  3. Engine is not running.
  4. The vehicle faces the receiver and is within the receiver range (signal is transmitted forward in the direction of travel).

Information
If programming a garage door opener or gate, it is advised to unplug the device during “cycling” process to prevent possible motor burn-up.


Fig. 71: Programming the garage door opener


Quick Index
View all Videos 

Models