The waiting call is accepted and activated. The previously active call is put on hold.
You then have the option to switch between the two calls or to establish a conference with both callers. To find out more, please refer to the section "Call waiting (swapping) and conference" on page 81.
The PCM will not accept a third incoming call. The caller hears the busy signal or is redirected to the mailbox.
Ending a connected call
Select "End active call".
The currently active call is ended and the first call that is on hold is activated again.
Call waiting (swapping) and conference
The "Call waiting & conf." function is only available if supported by the network provider.
When using the Bluetooth hands-free unit, this function is only available for a limited selection of devices.
A prerequisite for this function is that there are two calls, one of which is active and one of which is on hold (inactive). To find out more about this, please refer to the sections "Establishing an additional call" on page 62 and "Accepting a waiting call" on page 63.
Select "Call waiting & conf.".
You now have a number of options:
Swapping between the calls (call waiting)
The system swaps to the other call. The previously active call is put on hold.
Select "Swap" again to return to the call on hold.
To end one of the two calls, select "End call 1" or "End call 2". - or -
Select "End all" to end both calls.
Conferencing the two calls
Both calls are activated and connected so that all parties can speak to each other.
To end one of the two calls, select "End call 1" or "End call 2".- or -
Select "End all" to end the conference.