When parked, always put the electric parking
brake on and put the gearshift lever in neutral
or the PDK selector lever in position P.
On hills also turn the front wheels toward the
When emergency repairs become necessary, move the vehicle well off the road. Turn on the emergency flasher and use other warning devices to alert other motorists. Do not park or operate the vehicle in areas where the hot exhaust system may come in contact with dry grass, brush, spilled fuel or other flammable material.
Make it a habit to check the engine oil with every refueling.
Break in hints for the first
2,000 miles (3,000 kilometers) The following tips will be helpful in obtaining
optimum performance from your new Porsche.
Despite the most modern, high-precision
manufacturing methods, the moving parts must
still wear in with each other. This wearing-in occurs
mainly in the first 2,000 miles (3,000 km).
Preferably take longer trips.
Avoid frequent cold starts with short-distance driving whenever possible.
Avoid full throttle starts and abrupt stops.
Do not exceed maximum engine speed of 4200 rpm (revolutions per minute).
Do not run a cold engine at high rpm either in Neutral or in gear.
Do not let the engine labor, especially when driving uphill. Shift to the next lower gear in time (use the most favorable rpm range).
Never lug the engine in high gear at low speeds. This rule applies at all times, not just during the break-in period.
Do not participate in motor racing events,
sports driving schools, etc. during the first
2,000 miles (3,000 kilometers).
There may be a slight stiffness in the steering, gear-shifting or other controls during the break-in period which will gradually disappear.
Break in brake pads and brake disks
New brake pads and disks have to be "broken in", and therefore only attain optimal friction when the
car has covered several hundred miles or km.
The slightly reduced braking ability must be
compensated for by pressing the brake pedal
harder. This also applies whenever the brake pads
and brake disks are replaced.
New tires do not have maximum traction. They tend to be slippery.
Break in new tires by driving at moderate speeds during the first 60 to 120 miles (100 to 200 km). Longer braking distances must be anticipated.
Engine oil and fuel consumption
During the break-in period oil and fuel consumption may be higher than normal.
As always, the rate of oil consumption depends on
the quality and viscosity of oil, the speed at which
the engine is operated, the climate and road
conditions, as well as the amount of dilution and
oxidation of the lubricant.
Make a habit of checking engine oil with every refueling, add if necessary.