718

Cayenne

2009-2012 Cayman – Manual

2009-2012 Cayman – Manual

Page: 107

Allocating signals to the buttons

  • Please follow the operating instructions for the original hand-held transmitter.

Prior to programming the HomeLink for the first time
The following process deletes the standard codes set at the factory. Do not repeat the process if you program further buttons.

  • Keep the two outer buttons 1 and 3 depressed for approx. 20 seconds until lightemitting diode A begins to flash quickly.
    All programmed signals of buttons 1 to 3 are deleted.

Programming HomeLink with fixed code hand-held transmitters

  1. Press and hold the desired button until the light-emitting diode begins to flash slowly.
    You then have approx. 5 minutes to perform steps 2 and 3.
  2. Hold the original hand-held transmitter approx. 0 to 12 in. (0 to 30 cm) in front of the marked position (figure) on the vehicle.
  3. Press the transmit button on the original handheld transmitter until the daytime driving lights flash three times (up to approx. 45 seconds).
  4. Repeat steps 1 to 3 to allocate other buttons.

Programming HomeLink with changeable code hand-held transmitters

  1. Press and hold the desired button until the light-emitting diode begins to flash slowly.
    You then have approx. 5 minutes to perform steps 2 and 3.
  2. Hold the original hand-held transmitter approx. 0 to 12 in. (0 to 30 cm) in front of the marked position (figure) on the vehicle.
  3. Press the transmit button on the original handheld transmitter until the daytime driving lights flash three times (up to approx. 45 seconds).
  4. To synchronize the system:
    Press the programming button on the receiver for the garage door actuator.
    Afterwards, you usually have approx. 30 seconds to initiate step 5.
  5. Press the allocated HomeLink button twice.
    (With some devices, the button to be allocated must be pressed a third time in order to complete the setting process.)
  6. Repeat the programming steps to allocate other buttons.

Note
Several attempts with different distances between the vehicle and the original hand-held transmitter might be necessary.

The daytime driving lights will flash once the 5 minutes have been exceeded. Programming must be repeated from the beginning.

  • Please consult your authorized Porsche dealer if you have not been able to successfully allocate signals for the garage door opener to the buttons even though you have carefully followed the instructions in this chapter and the operating instructions for the original handheld transmitter.

Deleting programmed signals of the HomeLink (e.g., when selling the vehicle)
Keep the two outer buttons 1 and 3 depressed for approx. 20 seconds until light-emitting diode A begins to flash quickly.

All programmed signals of buttons 1 to 3 are deleted.

Quick Index
View all Videos 

Models